Samsung Dishwasher Error Code LC in Van Nuys

LC on a Samsung dishwasher is a leak error: the sensor in the machine's base has felt water where no water should be. The dishwasher stops to protect your floor — and the cause ranges from an actual leak to a tilted machine sloshing water into its own base.

$95diagnostic in Van Nuys — free when you repair with us. Full price quoted before we start.
Technician repairing a dishwasher
What’s broken?
Search our repair videos & guides — e.g. fridge not cooling, dryer noisy

What error LC means

Samsung dishwashers carry a leak sensor in the bottom tray. When moisture reaches it, LC sets and the machine halts, often running its drain pump insistently. Water gets there by leaking (hoses, pump seals, valve), by overflowing suds from the wrong detergent, or by a machine tipped during moving or install sloshing its sump into the tray. A dry tray with a persistent LC is a sensor or wiring story.

Van Nuys sits about 5 miles from our Reseda base, well inside our daily Valley loop — we pass through constantly, and same-day visits are straightforward.

How urgent is it? Water visible outside the machine: supply off, prompt appointment. LC with everything externally dry: within a few days — and no cycles meanwhile, in case the tray is telling the truth.

What causes error LC

An error code names the system that reported trouble — the diagnostic finds which of these is yours.

A genuine leak inside the machinePump seals, hose connections and the inlet valve weep with age; the tray collects the evidence a drop at a time until the sensor notices.
Suds overflow from wrong detergentDish soap or laundry detergent in the dispenser foams the tub over its seals and into the base — an LC with bubbles in its biography. The classic post-party LC.
Machine recently moved or installedTilting a dishwasher pours sump water into the base tray. LC within a day of a move, on a machine that then runs dry, is often just this puddle evaporating slowly.
Leak sensor or wiring faultThe sensor sits in the dampest neighborhood of the machine; its contacts corrode until it reports a permanent flood in a dry tray.

What you can safely check yourself

  • Look under the sink and around the machine's feet: any water outside the dishwasher is a real leak's signature — shut the supply valve under the sink and book promptly.
  • If a well-meaning guest used dish soap in the dispenser recently, confess it when you book: it changes the first hour of the diagnosis entirely.
  • Just had the machine installed or the kitchen floored? A move-related LC may clear once the base dries — but if it returns on the next cycle, it's a leak, not a puddle.
  • Don't keep resetting and running cycles: each run on a genuinely leaking machine adds water to a floor that has absorbed enough.

What our technician checks

The base tray is opened and read like a crime scene: wet or dry, water tracks traced to their highest point, pump seals and hose joints inspected under a test fill, and the sensor tested if the tray is dry. Leaks are fixed at their source — a sensor 'fixed' by drying alone, on a machine that's still leaking, is a return visit we've declined to schedule.

Parts most often involved: circulation and drain pump seals, hoses and clamps, water inlet valves, leak sensors. Each is identified against your exact model number.

$95diagnostic visit in Van Nuys — free when you repair with us
1 mo / 3 molabor warranty / parts warranty on every repair
≈5 mifrom our Reseda base — Van Nuys is regular route coverage

In Van Nuys the diagnostic visit is $95 — and nothing is hidden inside it: the technician tests the appliance properly, identifies the failed part by your model number, and quotes one total for the complete repair. Say yes and the diagnostic fee is credited toward the bill. Say no and that's the end of it — just the diagnostic fee, no pressure. The work itself is covered for 1 month on labor and 3 months on parts.

Samsung Dishwasher Error Code LC in Van Nuys — questions

Does LC always mean a leak?

It means water reached the leak sensor — by leaking, by suds overflow, or by a move-day slosh. A minority are the sensor itself failing. The tray inspection separates them in minutes; guessing separates you from money.

The code cleared after a few days. Am I fine?

If it was a move or a suds event, possibly — the tray dried. If it returns under normal use, water is arriving from somewhere, and 'somewhere' is a leak with a head start.

Why does the drain pump keep running with LC?

That's the machine protecting the floor: in leak mode many models run the drain to empty the tub and keep it empty. Annoying, intentional, and a sign the LC is being taken seriously by the only other party who can.

Book dishwasher repair in Van Nuys

Same-day slots fill up by midday. Call or email and we'll lock in your window.

Diagnostic $95 in Van Nuys — free when you repair with us. Full price in writing before we start. Labor warranty 1 month, parts warranty 3 months.

Book your visit online

Fill in the form, pick a day and an arrival window that work for you — your visit is reserved instantly. Prefer to talk? Call (747) 218-2666.

What will your diagnostic visit cost?

Pick your city and a few details — you see your exact diagnostic price before you book. The full diagnostic fee is credited toward your repair if you proceed with it.

Please review our service call terms:

• The diagnostic visit is $95 in most of our service area and $125 in Calabasas, Encino, Sherman Oaks and Arcadia. If you proceed with the repair, the full diagnostic fee is credited toward your repair — you pay only for the repair itself. If you decide not to repair, the diagnostic fee is due for the visit.

• Built-in and stacked units: in most cases (about 60%) we can diagnose a built-in unit in place. Sometimes a full diagnosis requires pulling the unit out (extraction), or removing a dryer stacked on top of a washer. Extraction is done only with your approval on site and costs extra, in addition to the diagnostic fee: removing a stacked dryer — $150; single built-in oven — $250; double built-in oven — $300; built-in refrigerator — from $600 (the exact price depends on the model and the access, and is quoted on site before any work begins). You may decline extraction and end the visit at any point — then only the diagnostic fee applies, even if a complete diagnosis is not possible without extraction.

• Confirming your visit: before heading out, your technician will text you to confirm. Please reply — if we don't receive a reply, your reserved slot will be released and the visit cancelled. If you need to cancel, please let us know before the technician heads out; once the technician has arrived, the diagnostic fee applies.

Please scroll the terms to the end to continue.

Call now Book a visit Diagnostic cost