GE Dishwasher Error Code C3 in North Hills

C3 on a GE dishwasher means it will not drain — the machine tried to empty and the water stayed. GE's C-codes are a drainage family (C1 drains too slowly, C2 takes too long), and C3 is the end of that road: standing water in the tub and a drain path to clear.

$95diagnostic in North Hills — free when you repair with us. Full price quoted before we start.
Technician repairing a dishwasher
What’s broken?
Search our repair videos & guides — e.g. fridge not cooling, dryer noisy

What error C3 means

The control times the drain phase and watches the level. C3 sets when the water doesn't leave at all. The blockage can be in the machine (filter, sump, pump), in the plumbing it's married to (air gap, garbage disposal knockout, drain hose), or in a pump that's simply done. New-install C3s have their own famous cause: the disposal's drain plug never removed.

North Hills sits about 4 miles from our Reseda base, well inside our daily Valley loop — we pass through constantly, and same-day visits are straightforward.

How urgent is it? Bail the tub if it's full and book within a few days. Standing gray water is a smell with a schedule; nothing else about C3 is urgent.

What causes error C3

An error code names the system that reported trouble — the diagnostic finds which of these is yours.

Clogged filter and sumpGE's fine filter and sump collect the residue of a thousand dinners; drainage slows over months until it stops. The maintenance cause, and the first inspection.
Blocked air gap or disposal connectionThe chrome cap by the faucet hides a classic clog; and on new disposals, the plastic knockout plug left in place makes draining mechanically impossible — the C3 that arrives with a new disposal is almost always this.
Drain pump failed or jammedA pump impeller jammed by a bone chip or glass shard, or a motor that's simply finished. Hum-versus-silence at drain time splits jam from death.
Kinked or clogged drain hoseThe hose run to the disposal crushed behind the machine or lined with years of grease felt.

What you can safely check yourself

  • Clean the filter first (it twists out of the tub floor) and check the sump for the glass shard or olive pit that pumps choke on — with the power off and care for sharp surprises.
  • Recently had a garbage disposal replaced? The knockout plug is suspect number one in the entire C3 universe — mention it when you book and save everyone an hour.
  • Run the disposal for thirty seconds: a disposal full of ground waste backs the dishwasher's drain up before it starts.
  • Check the air gap (the small chrome cylinder by the faucet): pop the cap and look for the clog — it is the drain path's narrowest toll booth.

What our technician checks

The drain is flow-tested in sections: pump output at the machine, hose flow, air-gap and disposal entry — each section proven to pass water before the next is suspected. Pumps are tested under load, because a pump that buzzes bravely and moves nothing is a pump being replaced.

Parts most often involved: drain pumps, filters and sump assemblies, drain hoses — and a knockout-plug removal that costs no parts at all. Each is identified against your exact model number.

$95diagnostic visit in North Hills — free when you repair with us
1 mo / 3 molabor warranty / parts warranty on every repair
≈4 mifrom our Reseda base — North Hills is regular route coverage

In North Hills the diagnostic visit is $95 — and nothing is hidden inside it: the technician tests the appliance properly, identifies the failed part by your model number, and quotes one total for the complete repair. Say yes and the diagnostic fee is credited toward the bill. Say no and that's the end of it — just the diagnostic fee, no pressure. The work itself is covered for 1 month on labor and 3 months on parts.

GE Dishwasher Error Code C3 in North Hills — questions

C1, C2, C3 — what's the difference?

One story in three chapters: C1 is a drain that's too slow to finish properly, C2 is a drain that takes too long, C3 is a drain that doesn't happen. They share a suspect list; C3 is just the most committed version.

Why did C3 start right after my new disposal?

Because the disposal ships with its dishwasher inlet sealed by a plastic plug that the installer is supposed to knock out. Forgotten plugs are a trade legend — the dishwasher drains into a wall. It's a ten-minute fix once known.

Can I keep running it if I bail the water out?

You'd be hand-draining a machine that exists to spare you exactly that — and each fill still ends at the same wall. Bail for hygiene, then book; the fix is usually in the path, not the wallet's deep end.

Book dishwasher repair in North Hills

Same-day slots fill up by midday. Call or email and we'll lock in your window.

Diagnostic $95 in North Hills — free when you repair with us. Full price in writing before we start. Labor warranty 1 month, parts warranty 3 months.

Book your visit online

Fill in the form, pick a day and an arrival window that work for you — your visit is reserved instantly. Prefer to talk? Call (747) 218-2666.

What will your diagnostic visit cost?

Pick your city and a few details — you see your exact diagnostic price before you book. The full diagnostic fee is credited toward your repair if you proceed with it.

Please review our service call terms:

• The diagnostic visit is $95 in most of our service area and $125 in Calabasas, Encino, Sherman Oaks and Arcadia. If you proceed with the repair, the full diagnostic fee is credited toward your repair — you pay only for the repair itself. If you decide not to repair, the diagnostic fee is due for the visit.

• Built-in and stacked units: in most cases (about 60%) we can diagnose a built-in unit in place. Sometimes a full diagnosis requires pulling the unit out (extraction), or removing a dryer stacked on top of a washer. Extraction is done only with your approval on site and costs extra, in addition to the diagnostic fee: removing a stacked dryer — $150; single built-in oven — $250; double built-in oven — $300; built-in refrigerator — from $600 (the exact price depends on the model and the access, and is quoted on site before any work begins). You may decline extraction and end the visit at any point — then only the diagnostic fee applies, even if a complete diagnosis is not possible without extraction.

• Confirming your visit: before heading out, your technician will text you to confirm. Please reply — if we don't receive a reply, your reserved slot will be released and the visit cancelled. If you need to cancel, please let us know before the technician heads out; once the technician has arrived, the diagnostic fee applies.

Please scroll the terms to the end to continue.

Call now Book a visit Diagnostic cost