Oven Not Heating in Duarte

The display says it's preheating; the oven stays cold. On gas ovens this is the igniter's famous failure; on electric, the element's. Both are diagnosed in minutes and fixed the same visit most of the time.

$95diagnostic in Duarte — free when you repair with us. Full price quoted before we start.
Technician repairing an oven
What’s broken?
Search our repair videos & guides — e.g. fridge not cooling, dryer noisy

What's going on with your oven

An oven that won't heat has usually failed at its heat source or the safety chain guarding it. Gas ovens depend on an igniter that must glow hot enough to open the gas valve — an igniter can glow orange and still be too weak, which surprises everyone. Electric ovens depend on elements that burn out visibly. Controls and sensors referee both. The result is one of the most satisfying diagnoses in appliance repair: short list, clear tests, common parts.

Duarte sits about 33 miles from our Reseda base, on the 210-corridor run we drive daily — same-day visits are straightforward.

How urgent is it? Not a hazard in most cases — a failed igniter is a closed valve by design. Book within the week; if you smell gas that doesn't clear, that's the gas utility's call, not ours.

What causes oven not heating

Every one of these is found by testing, not guessing — the diagnostic confirms which one you have before any part is quoted.

Weak or failed gas igniter (gas ovens)The flat or round igniter degrades until it can't draw enough current to open the safety valve. It may glow and still fail — brightness isn't the test, amperage is. The number-one oven no-heat cause.
Burned-out bake element (electric ovens)The lower element blisters, breaks, or burns through — often visibly. The broil element keeps working, which is why the oven 'sort of' heats from the top.
Failed temperature sensorThe sensor misreports the oven's temperature so badly the control never drives real heat — or the control faults out on impossible readings.
Control board / relay failureThe board's bake relay stops sending power to a healthy igniter circuit or element. Tested by output, condemned by evidence.
Gas safety valve failureLess common than the igniter it partners with: a valve that won't open even with a strong igniter signal. Proven after the igniter passes its test.
Burned wiring or terminal at the element/igniterHeat cycles cook the connections at the heat source over years — power dies inches from a healthy part.

What you can safely check yourself

  • Gas oven: look through the broiler-area or oven bottom at preheat — does the igniter glow at all? Glowing-but-no-flame after 60–90 seconds is the weak-igniter signature worth reporting.
  • Electric oven: inspect the bake (lower) element for blisters, holes or a section that doesn't glow red when on — visible element damage is its own diagnosis.
  • Try broil: if broil heats and bake doesn't, you've split the system in half for free — tell us.
  • Note any error codes (F-codes) on the display — oven controls are chatty about sensor and lock faults.

What our technician checks

The heat source is tested the way it fails: igniter amp draw against the valve's requirement (not just 'does it glow'), element continuity and condition, sensor resistance against its temperature chart, and board output under a bake call. Parts are replaced at the proven link — igniters are never sold by eyesight, because a tired igniter and a dead valve look identical from the door.

Parts most often involved in this repair: oven igniters, bake and broil elements, temperature sensors, gas safety valves and control boards. Each is identified against your exact model number — no universal substitutes.

$95diagnostic visit in Duarte — free when you repair with us
1 mo / 3 molabor warranty / parts warranty on every repair
≈33 mifrom our Reseda base — Duarte is regular route coverage

In Duarte the diagnostic visit is $95 — and nothing is hidden inside it: the technician tests the appliance properly, identifies the failed part by your model number, and quotes one total for the complete repair. Say yes and the diagnostic fee is credited toward the bill. Say no and that's the end of it — just the diagnostic fee, no pressure. The work itself is covered for 1 month on labor and 3 months on parts.

Oven Not Heating in Duarte — questions

Why does my gas oven igniter glow but the oven won't light?

Because the valve opens on current, not on light. A weakening igniter glows orange while drawing too little to open the valve — the most common oven failure there is, and invisible to the eye.

Can I cook with just the broiler?

Briefly and attentively, yes — broil elements usually share nothing with the bake failure. It's a workaround for tonight, not a repair strategy.

Is replacing an igniter a big repair?

No — it's among the most routine oven jobs, commonly under an hour with the part on the truck. It's also why 'oven not heating' is worth fixing on ovens of almost any age.

Book oven repair in Duarte

Same-day slots fill up by midday. Call or email and we'll lock in your window.

Diagnostic $95 in Duarte — free when you repair with us. Full price in writing before we start. Labor warranty 1 month, parts warranty 3 months.

Book your visit online

Fill in the form, pick a day and an arrival window that work for you — your visit is reserved instantly. Prefer to talk? Call (747) 218-2666.

What will your diagnostic visit cost?

Pick your city and a few details — you see your exact diagnostic price before you book. The full diagnostic fee is credited toward your repair if you proceed with it.

Please review our service call terms:

• The diagnostic visit is $95 in most of our service area and $125 in Calabasas, Encino, Sherman Oaks and Arcadia. If you proceed with the repair, the full diagnostic fee is credited toward your repair — you pay only for the repair itself. If you decide not to repair, the diagnostic fee is due for the visit.

• Built-in and stacked units: in most cases (about 60%) we can diagnose a built-in unit in place. Sometimes a full diagnosis requires pulling the unit out (extraction), or removing a dryer stacked on top of a washer. Extraction is done only with your approval on site and costs extra, in addition to the diagnostic fee: removing a stacked dryer — $150; single built-in oven — $250; double built-in oven — $300; built-in refrigerator — from $600 (the exact price depends on the model and the access, and is quoted on site before any work begins). You may decline extraction and end the visit at any point — then only the diagnostic fee applies, even if a complete diagnosis is not possible without extraction.

• Confirming your visit: before heading out, your technician will text you to confirm. Please reply — if we don't receive a reply, your reserved slot will be released and the visit cancelled. If you need to cancel, please let us know before the technician heads out; once the technician has arrived, the diagnostic fee applies.

Please scroll the terms to the end to continue.

Call now Book a visit Diagnostic cost