Home / Problems / Dryer Drum Not Turning / Woodland Hills

Dryer Drum Not Turning in Woodland Hills

The dryer heats (or tries), hums, but the drum sits still and the load stays in a wet heap. When the motor runs and the drum doesn't, the connection between them has failed.

$95diagnostic in Woodland Hills — free when you repair with us. Full price quoted before we start.
Technician repairing a dryer
What’s broken?
Search our repair videos & guides — e.g. fridge not cooling, dryer noisy

What's going on with your dryer

In most dryers a single belt wraps the drum and a motor pulley, and the drum rides on rollers, glides or a rear bearing. If the motor runs but the drum won't turn, the belt has almost always left the conversation. If nothing runs at all, you're in no-start territory instead. This page is for the hum-without-tumble: a mechanical failure with mechanical tells — including the thump-thump that often precedes it.

Woodland Hills sits about 5 miles from our Reseda base, well inside our daily Valley loop — we pass through constantly, and same-day visits are straightforward.

How urgent is it? Book within a few days, and stop running it meanwhile — stalled-drive motors overheat, and heat is what turns modest repairs into big ones.

What causes dryer drum not turning

Every one of these is found by testing, not guessing — the diagnostic confirms which one you have before any part is quoted.

Broken drive beltThe belt dries, cracks and eventually snaps — often audibly, mid-load. The motor runs free, the drum doesn't move, and on many models a belt switch stops the motor too.
Worn idler pulleyThe spring-loaded pulley that tensions the belt seizes or its wheel disintegrates; the belt slips, squeals, then fails. Belts and idlers are usually replaced as a team — they die together.
Seized drum rollersSupport rollers flat-spot and seize, first thumping rhythmically, then stopping the drum or shredding the belt.
Worn drum glides or rear bearingFront glides wear thin until the drum grinds its support; rear bearings dry out and bind. Rotation gets loud before it gets impossible.
Motor shaft or blower obstructionA blower housing packed with lint and debris can stall the whole drive — the motor is fine, its fan is choked.

What you can safely check yourself

  • Turn the drum by hand: it should rotate with moderate, even resistance. Gritty, lumpy or one-spot-stiff rotation is worn support hardware announcing itself.
  • Note whether the motor hums when you press start — hums means the drive is disconnected; silence means go to the won't-start list.
  • Recall the recent past: weeks of rhythmic thumping before today usually means rollers were dying in public.
  • Don't keep running it — a motor straining against a stalled drum overheats, and a simple belt job becomes a motor conversation.

What our technician checks

The cabinet comes open and the drive tells its story visually: belt condition and path, idler spring and wheel, roller surfaces, glide wear, drum bearing play. This is the most mechanical diagnosis in the laundry room — worn round things look worn, and the repair replaces the wear set that failed so the new belt isn't fed to the same seized roller.

Parts most often involved in this repair: drive belts, idler pulleys, drum support rollers, glide kits and drum bearings. Each is identified against your exact model number — no universal substitutes.

$95diagnostic visit in Woodland Hills — free when you repair with us
1 mo / 3 molabor warranty / parts warranty on every repair
≈5 mifrom our Reseda base — Woodland Hills is regular route coverage

In Woodland Hills the diagnostic visit is $95 — and nothing is hidden inside it: the technician tests the appliance properly, identifies the failed part by your model number, and quotes one total for the complete repair. Say yes and the diagnostic fee is credited toward the bill. Say no and that's the end of it — just the diagnostic fee, no pressure. The work itself is covered for 1 month on labor and 3 months on parts.

Dryer Drum Not Turning in Woodland Hills — questions

Why does my dryer hum but the drum won't turn?

The motor is running but disconnected from the drum — classically a snapped belt. The hum is the motor spinning free with nothing to drive.

Can I replace a dryer belt myself?

Handy owners do — but the belt is rarely the whole story: the idler and rollers that killed it are inspected at the same time in a proper repair, or the new belt meets the same fate.

What was that thumping noise before it quit?

Almost certainly a flat-spotted or seizing drum roller counting down. Thumping dryers are giving fair warning — it's the one noise worth booking on early.

Book dryer repair in Woodland Hills

Same-day slots fill up by midday. Call or email and we'll lock in your window.

Diagnostic $95 in Woodland Hills — free when you repair with us. Full price in writing before we start. Labor warranty 1 month, parts warranty 3 months.

Book your visit online

Fill in the form, pick a day and an arrival window that work for you — your visit is reserved instantly. Prefer to talk? Call (747) 218-2666.

What will your diagnostic visit cost?

Pick your city and a few details — you see your exact diagnostic price before you book. The full diagnostic fee is credited toward your repair if you proceed with it.

Please review our service call terms:

• The diagnostic visit is $95 in most of our service area and $125 in Calabasas, Encino, Sherman Oaks and Arcadia. If you proceed with the repair, the full diagnostic fee is credited toward your repair — you pay only for the repair itself. If you decide not to repair, the diagnostic fee is due for the visit.

• Built-in and stacked units: in most cases (about 60%) we can diagnose a built-in unit in place. Sometimes a full diagnosis requires pulling the unit out (extraction), or removing a dryer stacked on top of a washer. Extraction is done only with your approval on site and costs extra, in addition to the diagnostic fee: removing a stacked dryer — $150; single built-in oven — $250; double built-in oven — $300; built-in refrigerator — from $600 (the exact price depends on the model and the access, and is quoted on site before any work begins). You may decline extraction and end the visit at any point — then only the diagnostic fee applies, even if a complete diagnosis is not possible without extraction.

• Confirming your visit: before heading out, your technician will text you to confirm. Please reply — if we don't receive a reply, your reserved slot will be released and the visit cancelled. If you need to cancel, please let us know before the technician heads out; once the technician has arrived, the diagnostic fee applies.

Please scroll the terms to the end to continue.

Call now Book a visit Diagnostic cost